CREDITS SITEMAP CONTACT

You are in: home > equipment >

The Chin Rest Testing Kit

By Servaas Franssen, chin rest and shoulder rest technician
and Crissman Taylor, researcher

1. Height

First, The Chin Rest Testing Kit had to be adjustable by height. A commercial model chin rest called "Flesch round model" (sometimes called "Flesch neu") became the lowest chin rest in the testing kit. Four heights above it were added by adjusting the original chin rest upward. The original model has a fairly flat cup shape that fits many people, and the chin rest cup is placed over the tailpiece, a position which we had found from experience helped in the alignment of the violin with the bow and bow arm.

*The model usually called just "Flesch" has a bump in the center of the cup. This is not the one we used.

The five basic heights of the chin rests in The Chin Rest Testing Kit:

To achieve every height that we thought we would need, we designed an extensive collection of corks to allow finer adjustment of the height down to one millimeter. We were surprised how much difference just one millimeter makes in the way a chin rest feels.

The Chin Rest Testing Kit was designed using the following guidelines:

  1. We wanted to be able to achieve every height possible between the standard height of the "Flesch round model" chin rest and 3 cm higher.
  2. The higher a chin rest is, the greater are the leverage forces. (Higher chin rests would have a tendency to slide off the violin if you leaned your chin on it too hard.) Therefore, to keep higher chin rests stable, we attached the chin rest screws as low as possible to the base of the chin rest. This kept the chin rest securely fixed on the violin, allowing the player to practice and play normally.
  3. To create our basic chin rest set, we raised the standard chin rest by permanently attaching wooden blocks of different heights of 1 cm, 1.5cm, 2 cm and 2.5 cm.* The chin rest screws were then re-fixed to the attached blocks.
  4. Any height in between could then be achieved by placing slices of cork between the chin rest and the instrument. The cork slices differed in height from 1 to 4 mm. This made it possible to make the chin rest any height we wanted to within a millimeter.

* We noticed that we could raise the original standard
model chin rest up to 10 mm's with corks and still
have it be stable enough for the violinist to play for
a while. Therefore it was not necessary to have
a chin rest raised by 5 cm in the collection, since
we could raise the standard model using corks.

In between heights provided by cork slices:

Disclaimer | 2005 Faculty of Music (HKU) | Download Flash Player 7.0